57 stone specifications

  • What is Crushed Stone # 57?

     · # 57 Crushed Stone. This stone varies in size from a #4 sieve to a ¾ inch., This product is cubical and used for projects with a specification for the crush count or mixes. The crushed stone of ¾ inches is an aggregate size, and a ¾ inch square screen has been used to crush and reduce the size.

  • Stone Sizes | David H. Martin Excavating, Inc.

    PA2A. Size 2 Inch Topsize. Description. PA2A is a mixture of coarse stone and crushed stone dust. It is used as a road base or an under-slab fill. It will drain and has a structural coefficient, making it ideal when stability and drainage are a concern. PA2A is a primarily clean material. 2RC/ 2A Modified.

  • Welcome to The GDOT

    Welcome to The GDOT

  • What are the Different Gravel Sizes? (with pictures)

     · Gravel labeled #411 is usually a mixture of #57 and stone dust, and is particularly useful for patching potholes and sealing things like retaining walls. Decorative Options. Gravel known as size #1 is relatively large. Typically, this gravel ranges in diameter from 2.5 inches (6.35 centimeters) to 4 inches (10.16 centimeters).


    crushed stone, crushed slag, crushed or uncrushed gravel, or crushed or uncrushed chert, together with such material as manufactured sand or other fine materials naturally contained, or added thereto as needed to conform with these Specifications. The aggregate shall be of two classes: Class A …


    When standing water is in pipe foundation area, No. 57 stone can be used as a backfill in the sub‐foundation. No. 57 stone MUST be capped with a minimum of 4" crusher run prior to placement of pipe or box culvert. Compaction testing on No. 57 stone is not required; seat stone in trench.

  • Crushed Stone Supplier Roanoke, Lynchburg, Arvonia | Boxley

    Consists of #5, #56, #57, #68, #78, and #8 crushed stone. These aggregate products are typically used in asphalt and concrete mixes, but can also be used for driveways and septic systems. L-Series

  • Products

    FDOT #57 Stone (FDOT Code C10) Our #57 limestone meets the gradation requirements of the of the Florida Department of Transportation''s Standard Specifications Rule 14-103.006 – Section 5. Pg 8. 1.1.4 Section 901. The nominal size of this product is 0.5 to 1.5 inches in diameter.

  • ASTM 57 Stone Specifications | Hunker

    ASTM NO. 2 Stone (2 ½ inches) (Thickness is site specific) Underdrain (Optional Per Design) Geotextile Uncompacted Subgrade (Zero Slope) Open-graded Base Reservoir 4" (100mm) Thick ASTM NO. 57 Stone (3/4 inch) Open-graded Bedding Course 1½ to 2" (40 to 50mm) Thick ASTM NO. 8 Aggregate (3/8 inch) Borgert Pavers 31/8" (80 mm) Thick

  • Vulcan Materials

    Safety Data Sheets. Vulcan Materials Company, its subsidiaries and affiliates ("Vulcan"), have a long-standing, actively maintained and comprehensive stewardship program which is intended to be consistent with, or more protective than, applicable requirements of government standards for protecting human health, safety and the environment in the event of exposures to products which may be ...

  • New Jersey Department of Transportation

    New Jersey Department of Transportation Standard Specifications for Road and Bridge Construction 2007

  • Section 800 Coarse Aggregate

    #5 Stone #6 Stone #7 Stone #89 Stone 0.5 0.7 0.7 1.0 Flat and elongated particles (with lengths more than five times the average thickness). 10 Glassy particles (slag). 30 Other local detrimental substances. (Any combination) 2 e. Ensure that gravel used in asphaltic concrete and bituminous surface treatment meets the following additional

  • No. 8 (2.36 mm) No. 4 (4.75 mm) No. 30 (600 um) No. 16 (1 ...

     · Decant may be 0-2.5 for stone and slag. 4. When slag is used for separation layers as defined in 302.01, the total amount passing the No. 200 (75 µm) sieve shall be 10.0 to 12.0

  • TABLE 1005-1

    Sediment Control Stone : AST Mat Coat, Sediment Control Stone . Asphalt Plant Mix : Asphalt Plant Mix . Remarks. Author: Filler, Alfred L Created Date: 9/30/2015 1:57:46 PM ...

  • Specifications for materials under permeable pavement ...

     · Summary of specifications for materials under the pavement surface. For more information, see the footnote (1).Reference or links to any specific commercial product, process, or service by trade name, trademark, service mark, manufacturer, or otherwise does not constitute or imply endorsement, recommendation, or favoring by the Minnesota Pollution Control Agency.

  • Calculate #57 Granite Stone | cubic yards / Tons

    Calculate #57 Granite Stone. Type in inches and feet of your project and calculate the estimated amount of Granite Stone in cubic yards, cubic feet and Tons, that your need for your project. The Density of #57 Granite Stone: 2,410 lb/yd³ or 1.21 t/yd³ or 0.8 yd³/t.

  • Road Aggregate 101: Important Stuff

    The AASHTO system ranks specs according to size (1-10), with 1 being the largest (all material must pass a 4" sieve) and 10 being the smallest (all material passing a 3/8" sieve). Multi-digit specs represent a blend of one or more of the ten basic specs (i.e. AASHTO 57 is a blend of AASHTO 5 and AASHTO 7).


    Page 2-4 • Standards and Specifications for Stone Products 2016 Marble Institute of America 6.3 Applying Standard 51 to Natural Stone. When reviewing granite, marble, and other natural stones to the requirements of Standard 51, there are essentially two issues that …

  • #57 Limestone Gravel

    About #57 Limestone Gravel. #57 Stone is a crushed angular Limestone aggregate. Sizes of #57 Stone range from 1/2" to 1". #57 is one of the most popular and common gravels as it has a wide range of applications. If playback doesn''t begin shortly, try restarting your device. Videos you watch may be added to the TV''s watch history and influence ...

  • #57 gravel: Sizes, Prices & Uses

    The #57 sieve produces gravel materials that are approximately 1" – 1.5" in size. To put this into perspective, you can expect gravel in this size family to be around the same size as nickels and quarters. Depending on the quarry where it was manufactured, #57 crushed gravel …


    Specifications. 2018 NCDOT Standard Specifications. Table 1005-1 Aggregate Gradation – Coarse Aggregate. Table 1005-2 Aggregate Gradation – Fine Aggregate. Table 1012-1 Aggregate for Asphalt Pavements and Surface Treatments. Table 1012-5 Lightweight Aggregate Physical Properties. Table 1014-1 Gradation for Lightweight Coarse Aggregates.

  • AASHTO #57

    AASHTO #57. Spec Size: 1" Clean. Application: Driveway gravel, foundation backfill, slab on grade, subgrade material, concrete aggregate. Also referred to as: 2B. Specs with PennDOT 2A Other products. LAUREL AGGREGATES. R-8 Rip Rap . R-7 Rip Rap . R-6 Rip Rap ...

  • TxDOT Specifications

     · 346 - STONE MATRIX ASPHALT. SPECIFICATION REQUIREMENTS 1) Specify either a Performance Grade (PG) 76 binder or an Asphalt-Rubber (A-R) binder on the set of plans. 2) If different aggregate quality requirements (listed in Table 1) are desired, specify on the set of plans.

  • Construction Aggregates

    Thousands of years ago, civilizations built entire cities with stone, sand and gravel, and many of these ancient structures exist today. Our construction aggregates are used in a number of ways. As a base material underneath highways, walkways, airport runways, parking lots and railroads.

  • Percent Passing Range

    Class 2 Rip Rap ----- 12'''' - 24'''' (Heavier than 700 lb-0%, Heavier than 200 lb-50%, Less than 20 lb, 10% Max; Class 3 Rip Rap ----- 18'''' - 36'''' (Heavier than 2000 lb-0%, Heavier than 600 lb …

  • 57 Stone Gravel | Concrete, Limerock, Granite Driveways

    57 stone gravel. 57 stone is an aggregate material suitable for driveways, parking lots, construction site entrances, and pipe bedding among other things. The specifications are 1″ minus with very little powder. Generally #57 gravel is processed from concrete or Florida limerock. Granite is typically used when the application calls for a ...

  • 2012 Standard Specifications Manual

    2006 Specifications and Standard Drawings ; ... Type 1 select material is a fine aggregate material consisting of crushed stone screenings (washed or unwashed) meeting the gradation in Table 1016-1. ... Select material is a coarse aggregate material meeting the gradation requirements of standard size 57 in Table 1005-1 as described in Section ...

  • Specifications

    Previous Printed Specifications: US Customary Units. 2008 Standard Specifications. Metric Units. 2006 Standard Specifications. 2002 Standard Specifications. 1995 Standard Specifications.

  • Construction specifications for permeable pavement ...

     · Compact reservoir layers (layer with larger than No. 57 stone) with a 10 ton roller with two passes in static mode or until there is no visible movement of the aggregate. For No. 57 or similar sized stone layers, make two passes in vibratory mode and two passes in static mode or until there is no visible movement of the aggregate.

  • 2021 Standard Specifications

    2021 Standard Specifications. 2021 Standard Specifications Memo. Summary of Revisions for Standard Specifications. 2021 Standard Specifications for Road and Bridge Construction. 2021 Spec Book Order Form.

  • Standard Specifications for Road & Bridge Construction

    The Standard Specifications for Road and Bridge Construction contain requirements setting out or relating to the method or manner of performing work or to the quantities and qualities of materials and labor for all FDOT contracts. You will find links to the standard specifications documents for current and recent past FDOT projects in the ...

  • Section III: Surface Gravel

    the gravel could have been produced for use as base or cushion material for a paved road. There are two major differences between surface gravel and base (cushion) material. Good gravel for Section III: Surface Gravel Section III: Surface Gravel 39 base courses will generally have larger top-sized stone and a very small per-


    If gravel or limestone No. 57 or 67 size is selected in either of the above cases, ensure that the coarse aggregate incorporated into the concrete meets 703.02 and is tested according to ASTM C 666, Procedure B. Ensure that the area generated under the curve obtained by plotting the expansions of test specimens verses the number of test cycles ...

  • Material Specifications

    The material specifications are published in PDF format and may be accessed and printed upon acceptance of this agreement. This is a free service. By downloading files from this FTP service, you are agreeing to this License Agreement:

  • Crushed Stone & Gravel Description & Uses (New York …

    Gravel, 2" screened gravel x dust 2" Screened gravel subbase for concrete & asphalt driveways, etc. Gravel, 4" surge x 4" For lining banks alongside roadways & creeks; Gravel, AASHTO #57/ 1 & 2 blend x 1/2" 3/4" Subbase for concrete sidewalks; drainage stone

  • AASHTO #57 Crushed Stone | Union Quarries

    AASHTO #57 aggregate is a crushed stone grade that is gravel-like and made from a blend of stones five, six and seven. It comes from natural rock, so the pieces are jagged and angular. What Is #57 Crushed Stone? AASHTO #57 consists of many common kinds of rocks, including quartzite, washed gravel, granite, argillite, limestone and traprock.

backto top